Step 1 Peel adhesive liner and attach first SUPERSTRIP along bottom edge of the Display Area (Tip: mark bottom edge with a pencil first)
Step 2 Cut 3 SPACERS 1/8-inch (3mm) taller than prints to be mounted Insert SPACERS 1/8-inch (3mm) into slot (to adhesive backing)
Step 3 Attach second SUPERSTRIP using SPACERS as a guide (Tip: peel liner back in short sections and tack lightly at SPACERS first)
Step 4 Repeat Steps 2 & 3 to add more SUPERSTRIPS®
Mounting Photographs
Step 1 - Position
Step 2 - Secure
Step 3 - Release
To position print, push top edge into upper slot (1) and slide left or right (2)
To secure print, push bottom edge 1/8-inch (3 mm) into lower slot (3)
To release print, reverse (3) or pull top edge out of upper slot and pull out (4)
Additional Tips
Wall-Album®, SUPERSTRIPS®, PlayMaker®, Bathbar® & Washbar® are trademarks of Biospace Corporation. Biospace® is a registered trademark of Biospace International AG. © Biospace Corporation. All rights reserved. U.S. and International Patents apply or are pending.
Best viewed with Microsoft® Internet Explorer 4 or greater. Kindly report any problems with this page to Webmaster.
